Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the muffler of the Keeway K-Light 202?

Model: Keeway K Light 202
Part: Exhaust muffler

Video tutorial

To replace the exhaust of the Keeway K-Light 202, you need to loosen the screws that attach it to its housing: this will be located near the rear wheel, on the right side of the motorcycle. At this point, it will be possible to widen the connecting clamp positioned between the exhaust and the exhaust manifold: the terminal can now be completely removed so that the new one can be inserted.

After installing the new exhaust, you can access the engine to verify that everything is functioning correctly.


Posted on 24 October 2025 by ScegliAuto


Related tutorials

How to Replace the Exhaust on the Keeway K Light 202
How to Replace the Exhaust on the Keeway K Light 202
K Light 202 .. To replace the exhaust on the Keeway K Light 202, loosen the screws that secure it to the corresponding supports and also unscrew the screw.. …
How to Adjust the Valves on the Keeway K Light 202
How to Adjust the Valves on the Keeway K Light 202
K Light 202 .. To adjust the valves on the Keeway K-Light 202, you need to loosen the screws that secure the valve cover, located on the right side of the.. …
How to replace the air filter on the Keeway K-Light 202?
How to replace the air filter on the Keeway K-Light 202?
K Light 202 .. To replace the air filter on the Keeway K-Light 202, loosen the side panel located on the right side of the bike, just below the fuel tank. Once.. …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos