Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the muffler of the KTM XCW 300?

Model: Ktm Xcw 300
Part: Exhaust muffler

Video tutorial

To replace the exhaust pipe of the KTM XCW 300, you need to loosen the screws that secure the exhaust terminal to its housing on the left side of the motorcycle, near the rear fender. Once these screws have been loosened, you can proceed to widen the ring that connects the exhaust pipe to the manifold.

By doing this, the old exhaust pipe can be completely detached from its seat in order to insert the new one. Once the new one has been properly fixed and connected, it is necessary to check that it functions correctly.


Posted on 24 February 2025 by ScegliAuto


Related tutorials

How do you replace the battery of the KTM XCW 300?
Xcw 300 In order to replace the battery of the KTM XCW 300, you will need to loosen the screw located in the front part of the seat: this way it will be poss…
How to Replace the Clutch Discs on the KTM XCW 300
How to Replace the Clutch Discs on the KTM XCW 300
Xcw 300 Today, follow these instructions to remove and replace the clutch discs on the KTM XCW 300 enduro bike. First, place the bike on a stand and start by…
Replacing the Front Brake Pads and Brake Fluid on a KTM XCW 300
Replacing the Front Brake Pads and Brake Fluid on a KTM XCW 300
Xcw 300 In this video, you will see how to remove and replace the front brake pads and how to replace the brake fluid on a KTM XCW 300, following these simpl…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos