Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Ktm Exc F 350
Part: Brake pads

It will be possible to replace the brake pads of the KTM EXC-F 350 following the same procedure for both the front wheel and the rear wheel: once the screws have been unscrewed, it will be possible to detach the calipers from the corresponding discs so that the pads can then be released from inside the caliper. At this point, it will be possible to place the new pads inside the caliper: by reattaching the caliper to the corresponding disc, it will be possible to operate the brake lever to verify that everything is functioning correctly.

Posted on 9 June 2025 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Brake and Clutch Levers on the KTM EXC-F 350
Replacing the Brake and Clutch Levers on the KTM EXC-F 350
Exc F 350 .. the brake and clutch levers on the KTM EXC-F 350 enduro bike. First, remove the front brake lever; to do this, unscrew the fixing bolt of the lever.. …
How to Replace the Clutch Lever on a KTM EXC 350
How to Replace the Clutch Lever on a KTM EXC 350
Exc F 350 This guide provides the main instructions for removing and replacing the clutch lever (also applicable to the front brake lever) on the KTM EXC 350 e…
How to Replace the Battery of the KTM EXC-F 350?
How to Replace the Battery of the KTM EXC-F 350?
Exc F 350 .. You can replace the battery of the KTM EXC-F 350 by inserting the ignition key into the lock located at the front of the seat: once it is released,.. …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos