Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch on the KTM SX 50

Model: Ktm Sx 50
Part: Clutch

Video tutorial

This guide provides instructions on how to dismantle and replace the clutch assembly of the KTM SX 50 enduro bike. First, place the bike on a stand and begin by unscrewing the oil drain bolt located on the sump, allowing it to drain into a container; remove the screws from the clutch cover to take it off, as shown in the video.

Next, unscrew the central screws of the clutch pack, removing it and replacing all the discs one by one; check the wear condition of the thrust washer, replacing it if necessary, then refit the clutch cover and top up with new oil!


Posted on 23 March 2026 by ScegliAuto


Related tutorials

How to Replace the Clutch on a KTM SX 50?
How to Replace the Clutch on a KTM SX 50?
Sx 50 To replace the clutch on the KTM SX 50, loosen the screws securing the clutch cover panel located on the right side of the bike: once the screws are …
How to Replace the Clutch on the Ktm SX 50?
How to Replace the Clutch on the Ktm SX 50?
Sx 50 In this short and simple guide, you will see the steps to disassemble and replace the clutch discs on the Ktm XC 250 enduro bike. First, place your b…
How do you replace the clutch of the KTM SX 50?
How do you replace the clutch of the KTM SX 50?
Sx 50 It will be possible to replace the clutch of the KTM SX 50 by loosening the screws that secure the cover casing located on the right side of the bike…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos