Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Coolant in a KTM 1290 Super Adventure R

Model: Ktm 1290 Super Adventure R
Part: Antifreeze coolant

Video tutorial

The instructions in this guide will show you how to bleed and top up the coolant in the engine of the KTM 1290 Super Adventure motorcycle. First, place the bike on a stand and start by unscrewing the coolant bleed screw, removing the fluid contained within the circuit with a vacuum pump.

Next, unscrew the cap of the reservoir and after removing the fluid inside, top up with the appropriate new coolant, filling to the maximum level mark.


Posted on 29 May 2026 by ScegliAuto


Related tutorials

How to Replace the Key Fob Battery of the KTM 1290 Super Adventure R?
How to Replace the Key Fob Battery of the KTM 1290 Super Adventure R?
1290 Super Adventure R In this tutorial, see how to replace the battery of the key fob for the KTM 1290 Super Adventure R, a very simple and quick operation. You will need …
How to reset the service light on the KTM 1290 Super Adventure R?
How to reset the service light on the KTM 1290 Super Adventure R?
1290 Super Adventure R This tutorial shows how to reset the service light on the KTM 1290 Super Adventure R, a very simple and quick operation to be performed only after co…
How to Reset the Service Light on a KTM 1290 Super Adventure R?
How to Reset the Service Light on a KTM 1290 Super Adventure R?
1290 Super Adventure R In this tutorial, you will see how to reset the service light on a KTM 1290 Super Adventure R, a very simple and quick operation to perform only afte…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos