Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Headlamp Bulb on a KTM Duke 200

Model: Ktm Duke 200
Part: Headlight bulb

Video tutorial

In today's video, you will learn how to remove and replace the front headlamp bulb on a KTM Duke 200. First, remove the side screws located near the instrument panel; then, remove the plastic side screws and take out the display along with the two nuts of the headlamp to access the bulb.

At this point, disconnect the electrical connector of the bulb and unclip the metal spring: simply remove the bulb and replace it with a new one of the correct type (in this case, H4 fitting).

Reassemble everything.


Updated on 7 April 2026 by ScegliAuto


Related tutorials

How to Replace the Front Headlamp Bulb on a KTM Duke 200?
How to Replace the Front Headlamp Bulb on a KTM Duke 200?
Duke 200 In this tutorial, you will see how to replace the front headlamp bulb on a KTM Duke 200, a very simple and quick operation. First, ensure the key is …
How to Replace the Front Headlamp Bulb on the KTM Duke 200?
How to Replace the Front Headlamp Bulb on the KTM Duke 200?
Duke 200 As shown in this tutorial, replacing the front headlamp bulb on the KTM Duke 200 is a very simple and quick task. Before proceeding, ensure the key i…
How to Replace the Front Headlamp on a KTM Duke 200?
How to Replace the Front Headlamp on a KTM Duke 200?
Duke 200 In this tutorial, we will see how to replace the front headlamp on a KTM Duke 200, a very simple and quick operation. First, ensure that the key is n…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos