Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Ktm
    3. : 950 Adventure

Service on KTM 950 Adventure

Model: Ktm 950 Adventure
Part: Checks and maintenance

Video tutorial

Start the engine for a few minutes to warm the oil, making it less viscous and facilitating drainage. Unscrew the bolt that acts as a plug for the lower drain hole and collect the used oil in a container (dispose of it properly).

While the lubricant drains, unscrew the oil filter and check its condition: if it is slightly dirty, just clean it; otherwise, replace it (if replacing, remember to lubricate the O-ring of the new filter, using old oil is fine as long as it is not dry). Close the lower hole, measure the amount of oil drained, and refill the same amount through the upper fill hole.


Updated on 16 April 2026 by ScegliAuto


Related tutorials

Change the Engine Oil and Oil Filter on a KTM LC8 950 Adventure
Lc8 950 Adventure In this video tutorial, you will see step-by-step instructions for performing the routine maintenance oil change on the KTM LC8 950 Adventure motorcy…
How to Reset the Service Light on a KTM 390 Adventure
How to Reset the Service Light on a KTM 390 Adventure
390 Adventure If you want to manually reset the service light on the dashboard of your KTM 390 Adventure, carefully read the following guide and follow the steps d…
How to Reset the Service Light on a KTM 390 Adventure?
How to Reset the Service Light on a KTM 390 Adventure?
390 Adventure To reset the service light on a KTM 390 Adventure, turn on the ignition by inserting the key into the ignition switch. Once the dashboard is illumina…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos