Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Perform a Service on the KTM LC4 640 SM

Model: Ktm Lc4 640 Sm
Part: Engine oil

Video tutorial

Let's see how to carry out the regular maintenance service, including an oil change and oil filter replacement, on a KTM LC4 640 SM enduro bike. First, remove the metal protection plate located at the bottom of the engine; then, unscrew the oil drain bolt found underneath the engine, allowing the oil to drain into a container.

Next, use the appropriate tool to remove the oil filter; replace it with a new one, tightening it by hand. Finally, pour in the new engine oil, filling it to the correct level!


Updated on 16 April 2026 by ScegliAuto


Related tutorials

How to Replace the Clutch on the KTM LC4 640 SM
How to Replace the Clutch on the KTM LC4 640 SM
Lc4 640 Sm To replace the clutch on the KTM LC4 640 SM, first loosen the bolts securing the engine guard plate at the bottom of the bike. Once this plate is rem…
How to Replace the Air Filter on a KTM LC4 640 SM?
How to Replace the Air Filter on a KTM LC4 640 SM?
Lc4 640 Sm To replace the air filter on a KTM LC4 640 SM, loosen the screws securing the left side cover of the bike, just below the seat. Once the cover is rem…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos