Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the engine oil on a KTM SX 50

Model: Ktm Sx 50
Part: Engine oil

Video tutorial

Let’s discover all the steps to perform the routine maintenance oil change on the KTM SX 50cc motorcycle, in simple and quick steps. First, position the stand on your motorcycle and start by unscrewing the oil drain bolt located under the engine, using a socket spanner; let the oil drain into a container for about ten minutes.

At this point, you can open the fill hole and pour in the new engine oil, with the correct grade; just fill to the maximum level, following the video to the end!


Updated on 9 May 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil on a KTM SX 50
How to Change the Engine Oil on a KTM SX 50
Sx 50 Let's discover in this short and simple guide how to perform the routine maintenance service for changing the oil on the KTM SX 50 enduro bike. First…
How to Clean the Air Filter of the KTM SX 50
How to Clean the Air Filter of the KTM SX 50
Sx 50 Follow this brief and simple guide for instructions on how to remove and clean the air filter of the KTM SX 50 engine. First, place your bike on a st…
How to Replace the Crankshaft Seal on the KTM SX 50
How to Replace the Crankshaft Seal on the KTM SX 50
Sx 50 In this video tutorial, follow the instructions to remove and replace the crankshaft seal on the KTM SX 50 in simple steps. First, remove the sprocke…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos