Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Ktm
    3. : 640 Adventure

How to start a KTM 640 Adventure

Model: Ktm 640 Adventure
Part: Checks and maintenance

This video is currently unavailable

Before you begin, position your KTM 640 Adventure on the centre stand. Start by inserting and turning the key in the ignition switch.

Next, open the fuel tap located below the left front fairing. After that, pull out the engine start lever located at the bottom left of the engine block.

Then, pull and hold the clutch lever while quickly pressing the engine start lever several times until the engine starts. Once the engine is running, release the clutch lever and close the engine start lever, and the procedure is complete.


Updated on 12 May 2026 by ScegliAuto


Related tutorials

How to Perform a Service on the KTM LC4 640 SM
How to Perform a Service on the KTM LC4 640 SM
Lc4 640 Sm Let's see how to carry out the regular maintenance service, including an oil change and oil filter replacement, on a KTM LC4 640 SM enduro bike. Firs…
How to Replace the Air Filter on a KTM LC4 640 SM?
How to Replace the Air Filter on a KTM LC4 640 SM?
Lc4 640 Sm To replace the air filter on a KTM LC4 640 SM, loosen the screws securing the left side cover of the bike, just below the seat. Once the cover is rem…
How to Replace the Clutch on the KTM LC4 640 SM
How to Replace the Clutch on the KTM LC4 640 SM
Lc4 640 Sm To replace the clutch on the KTM LC4 640 SM, first loosen the bolts securing the engine guard plate at the bottom of the bike. Once this plate is rem…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos