Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing and Refilling the Brake Fluid of the KTM Duke 390

Model: Ktm Duke 390
Part: Brake fluid

Video tutorial

In today's tutorial video, you will see the instructions for replacing the rear brake fluid of the KTM Duke 390, as well as the 125. First, remove the cover of the rear brake fluid reservoir; then drain the fluid into a container. Next, bleed the fluid at the brake caliper by opening the small valve and pressing the brake lever to allow drainage; finally, refill the reservoir with the correct new brake fluid!


Updated on 14 June 2026 by ScegliAuto


Related tutorials

How do you replace the motor oil of the KTM Duke 390?
How do you replace the motor oil of the KTM Duke 390?
Duke 390 To perform the oil change on the KTM Duke 390, you will need to loosen the drain plug of the oil pan located in the central lower part of the vehicle…
How do you replace the clutch of the KTM Duke 390?
How do you replace the clutch of the KTM Duke 390?
Duke 390 To replace the KTM Duke 390, you will need to loosen the screws that secure the clutch protection cover, located on the right side of the vehicle in …
How to Reset the "Service" Light on a KTM Duke 390
How to Reset the "Service" Light on a KTM Duke 390
Duke 390 Before starting, the regular service should already have been performed, and then you need to sit on the rider's seat of your KTM Duke 390. Start by …

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos