Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Wheel and Brake Caliper on a Ktm Duke 390

Model: Ktm Duke 390
Part: Wheel

Video tutorial

In today's tutorial video, you will learn how to remove and replace the front wheel and how to take off the brake caliper (for pad replacement) on a Ktm Duke 390, as well as the Duke 125. First, lift the motorcycle with a stand; then, unscrew the central axle of the front wheel using a socket spanner.

At this point, unscrew the two fixing screws of the brake caliper to remove it from the disc; if necessary, replace the brake pads.

Finally, reassemble everything by applying the reverse procedure of disassembly!


Updated on 14 June 2026 by ScegliAuto


Related tutorials

Replacing and Refilling the Brake Fluid of the KTM Duke 390
Replacing and Refilling the Brake Fluid of the KTM Duke 390
Duke 390 In today's tutorial video, you will see the instructions for replacing the rear brake fluid of the KTM Duke 390, as well as the 125. First, remove th…
How to Reset the "Service" Light on a KTM Duke 390
How to Reset the "Service" Light on a KTM Duke 390
Duke 390 Before starting, the regular service should already have been performed, and then you need to sit on the rider's seat of your KTM Duke 390. Start by …
Removing the rear wheel of the Ktm Duke 390
Removing the rear wheel of the Ktm Duke 390
Duke 390 Today, we will go through the instructions to remove and replace the rear wheel or tyre of the Ktm Duke 390 motorcycle. First, place the motorcycle o…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos