Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch on the KTM SMC 690

Model: Ktm Smc 690
Part: Clutch

Video tutorial

Follow these instructions to remove and replace the clutch discs on the KTM SMC 690 motorcycle. First, place your motorcycle on a stand and start unscrewing and removing the screws from the clutch cover, located on the right; once removed, you can access the clutch pack, as shown in the video.

At this point, unscrew the screws from the clutch plate, then remove all the other discs; check for wear and replace the clutch with a new one suitable for your engine, applying the reverse procedure for reassembly!


Updated on 26 June 2026 by ScegliAuto


Related tutorials

How to Replace the Sprocket on KTM SMC 690
How to Replace the Sprocket on KTM SMC 690
Smc 690 In today's video, we will see how to disassemble and replace the drive sprocket on a KTM SMC 690, following the instructions below. First, remove the…
How do you replace the exhaust of the KTM SMC-R 690?
How do you replace the exhaust of the KTM SMC-R 690?
Smc 690 In order to replace the exhaust of the KTM SMC-R 690, you will need to loosen the screws that fix the exhaust terminal to its housing near the rear f…
Fuel Filter Replacement KTM SMC 690
Fuel Filter Replacement KTM SMC 690
Smc 690 In this video, we will see the main steps to remove and replace the fuel filter on a KTM SMC 690. First, remove all the petrol from the tank, either …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos