Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil in a KTM Duke 390?

Model: Ktm Duke 390
Part: Engine oil

Video tutorial

In this tutorial, you can see how to change the engine oil in the KTM Duke 390, a very simple operation. First, wait for the engine to cool completely, then undo the two drain bolts indicated, one located on the left side and the other at the bottom.

Allow all the oil contained in the circuit to drain out and remove the small filters located inside the holes. Next, unscrew the cover of the main filter, remove it, and insert the replacement.

Finally, tighten each cap and fill the required amount of oil through the upper hole.


Updated on 18 July 2026 by ScegliAuto


Related tutorials

How to Replace the Engine Oil in the KTM Duke 390?
How to Replace the Engine Oil in the KTM Duke 390?
Duke 390 As you can see in this tutorial, replacing the engine oil in the KTM Duke 390 is a very simple and quick task. Before proceeding, wait until the engi…
How do you replace the motor oil of the KTM Duke 390?
How do you replace the motor oil of the KTM Duke 390?
Duke 390 To perform the oil change on the KTM Duke 390, you will need to loosen the drain plug of the oil pan located in the central lower part of the vehicle…
How to Perform a Service on the KTM Duke 390
Duke 390 Discover how to carry out routine maintenance on the KTM Duke 390 by replacing the engine oil and oil filter. First, place the motorcycle on its cent…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos