Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Battery on a KTM RC 135

Model: Ktm Rc 125
Part: Battery

Video tutorial

Today, we will discover the instructions that will allow you to remove and replace the battery on a KTM RC 125, following the instructions below. First, place your bike on a stand and begin removing the plastic cover located at the top of the fuel tank; then disconnect both battery terminals (positive and negative), as shown in the video.

At this point, remove and replace the battery with a new one of the correct type and the same amperage, finally reassembling the plastic fairing located above the tank!


Updated on 13 August 2026 by ScegliAuto


Related tutorials

How to Replace the Battery in the KTM RC 125?
How to Replace the Battery in the KTM RC 125?
Rc 125 In this tutorial, see how to replace the battery in the KTM RC 125, a very simple and quick operation. Before proceeding, ensure the key is not inser…
How to adjust the time on the KTM RC 125?
Rc 125 In this tutorial, we can see how to adjust the time on the KTM RC 125, an extremely simple and quick operation to be carried out, for example, after …
How to set the time on the KTM RC 125?
How to set the time on the KTM RC 125?
Rc 125 In this tutorial, you can see how to set the time on the KTM RC 125, a very simple and quick operation to perform after disconnecting the battery or …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos