Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Fuel Tank from the KTM Duke 390

Model: Ktm Duke 390
Part:

Video tutorial

Today, we will go through the instructions to remove and replace the fuel tank on the KTM Duke 390 motorcycle. First, place the bike on a stand and start by removing the rider's seat.

Then, unscrew the screws securing the side plastic fairings to remove them, as shown in the video. At this point, unscrew the screws of the fuel tank, disconnect the electrical connector and the fuel line located underneath to remove it completely.

Replace it with a new one if necessary, applying the reverse procedure for reassembly!


Updated on 19 August 2026 by ScegliAuto


Related tutorials

Removing the Fuel Tank from a KTM Duke 390
Duke 390 Today, we will see how to remove the tank from a KTM Duke 390 in simple steps. First, remove the rear seat and unscrew the fastening screws of the ri…
Replacing and Refilling the Brake Fluid of the KTM Duke 390
Replacing and Refilling the Brake Fluid of the KTM Duke 390
Duke 390 In today's tutorial video, you will see the instructions for replacing the rear brake fluid of the KTM Duke 390, as well as the 125. First, remove th…
How to Reset the "Service" Light on a KTM Duke 390
How to Reset the "Service" Light on a KTM Duke 390
Duke 390 Before starting, the regular service should already have been performed, and then you need to sit on the rider's seat of your KTM Duke 390. Start by …

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos