Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the engine oil and oil filter of the KTM Adventure 990

Model: Ktm Adventure 990
Part: Engine oil

Video tutorial

To replace the engine oil and oil filter, no special tools are needed; let's see how to perform the service on the KTM Adventure 990. First, place the bike on its stand and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the screws of the oil filter cover, removing and replacing the cartridge with the new one, as shown in the video.

At this point, unscrew the filler screw and top up with new oil, filling to the maximum level mark.


Updated on 5 September 2026 by ScegliAuto


Related tutorials

How to Replace the Engine Oil and Oil Filter on a KTM Adventure 990
How to Replace the Engine Oil and Oil Filter on a KTM Adventure 990
Adventure 990 Let's discover the steps and instructions on how to perform the routine maintenance service by replacing the engine oil and oil filter on a KTM Adven…
How to Replace the Air Filter in the KTM Adventure 990
How to Replace the Air Filter in the KTM Adventure 990
Adventure 990 In this tutorial, see how to replace the air filter in the KTM Adventure 990, a very simple and quick operation. First, insert the key into the left …
How to Remove the Fuel Tank from a KTM Adventure 990
How to Remove the Fuel Tank from a KTM Adventure 990
Adventure 990 These brief and simple steps will show you how to remove and replace the fuel tank on the KTM Adventure 990 motorcycle. First, place the motorcycle o…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos