Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Model: Ktm Duke 790
Part: Engine oil

Let's see how to change the engine oil of the Ktm Duke. Place the motorcycle on the center stand and unscrew the oil refill cap. Move to the left side of the motorcycle and position a basin to collect the used oil under the oil pan. Unscrew the two nuts on the right side that correspond to the mesh caps, remove them, and the oil will start to drain into the basin. Clean the filters with a specific detergent. Proceed to remove the cartridge filter cap, located to the left of the previous filters, and slide it out of its seat. Once the old oil has been drained, begin by reinstalling the cartridge filter, applying a thin layer of oil on the rubber gaskets and the two mesh filters, and tightening the caps with a torque wrench. Now, pour in the new oil using a funnel: start by adding approximately two liters, start the motorcycle and let the engine run for a few minutes, then finish filling the oil pan with approximately 0.8 liters, checking the correct level through the appropriate sight glass.


Posted on 2 February 2024 by ScegliAuto



How to replace the engine oil in the KTM Duke 790?
Duke 790 In this tutorial we can see how to replace the engine oil in the KTM Duke 790, an extremely simple and fast operation. First of all, make sure that t
How to replace the motor oil in the KTM Duke 790?
Duke 790 In this tutorial, we can see how to replace the engine oil in the KTM Duke 790, an extremely simple and quick operation. First of all, make sure that
How to replace the engine oil and oil filter of the Ktm Duke 790.
Duke 790 Today we will see the procedure for performing ordinary maintenance on the Ktm Duke 790 motorcycle, which involves changing the engine oil and oil fi

How do you remove the rear wheel of the Piaggio BV 350?

In order to remove the rear wheel of the Piaggio BV 350, you need to loosen the screws that secure it to its housing, located at the base of the rear swingarm. Once the screws holding the central axle of the wheel have been removed, it will be possible to slide it out and loosen the screws holding the rear caliper to the corresponding brake disc. The wheel will then be completely freed from its housing and you can proceed to install the new one: the removed parts must be reinstalled, making sure everything works properly.

Watch the video!


by ScegliAuto

More videos