Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on the KTM 390

Model: Ktm Ktm 390
Part: Service warning light

Video tutorial

Resetting the service light on the 2021 KTM 390 is a very simple operation. Start the reset by pressing the button on the left side of the handlebars, labelled SET. Once pressed, you will gain access to the menu, where you need to navigate using the down arrow button.

Using the arrow button, select the "settings" option and then press both the up and down arrow buttons for about 5 seconds as shown in the video. From here, you will access the service reset.

Set the new service interval and turn off the ignition on your KTM 390.


Updated on 26 September 2026 by ScegliAuto


Related tutorials

How to Reset the Service Light on a KTM 390
How to Reset the Service Light on a KTM 390
Ktm 390 Resetting the service light on the KTM 390 is a straightforward task that you can easily do yourself, aided by our brief video tutorials. Start the r…
How to Fit the Rear Mudguard on a KTM 390 Adventure?
How to Fit the Rear Mudguard on a KTM 390 Adventure?
Ktm 390 To fit the rear mudguard on your KTM 390 Adventure, follow these steps. First, clean the rear fork thoroughly to ensure a clean surface free of debri…
How to change the engine oil on a KTM 390?
How to change the engine oil on a KTM 390?
Ktm 390 To change the engine oil on a KTM 390, first ensure that the bike is on a flat and stable surface. Lift the bike using a centre stand or appropriate …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos