Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the headlight bulb of the Kymco People GT 300i, you need to loosen the screws that secure the front panel of the fairing: the fixing screws will be located on the front bottom and immediately below the handles. Once all these screws have been loosened, you can proceed by detaching the panel and gaining access to the inside of the headlight unit: by removing the cover, you can disconnect the connector from the corresponding bulb, so that it can be removed and replaced with a new spare part.

Posted on 3 February 2025 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Headlamp Bulb on Kymco People GT 300i
Replacing the Front Headlamp Bulb on Kymco People GT 300i
People Gt 300i Let’s see how to disassemble and replace the front headlamp bulb on a Kymco People GT 300i scooter. First, remove the mirrors by taking off the rubbe…
How to Replace the Belt on Kymco People GT 300i
How to Replace the Belt on Kymco People GT 300i
People Gt 300i Below are the instructions that will allow you to remove and replace the drive belt on the Kymco People GT 300i scooter by following these simple ste…
Guide to disassembling the rear light of the Kymco People GT 300i
Guide to disassembling the rear light of the Kymco People GT 300i
People Gt 300i Today's guide will show us the main steps useful for disassembling and replacing the rear headlight and its bulbs of the Kymco People GT 300i scooter…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos