Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Remove the cap from the centre of the shield and unscrew the now-exposed screw with a crosshead screwdriver, then unscrew the screw underneath (going in a bit blind) and the two upper screws near the handlebars. Now you can pull off and remove the bulb cover, subsequently disconnecting the connector and detaching the bulb, which is simply clipped in, like most car bulbs (though it may not be the same as the aforementioned). Insert the new bulb and reattach the clips. Reassemble everything in reverse order: insert the connector, the cover, and then the shield, screwing in all the screws.

Updated on 18 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Brake Light Bulb on Kymco Agility 200i
Replacing the Brake Light Bulb on Kymco Agility 200i
Agility 200i First, remove the scooter's battery (unfortunately, the only access is from here, behind the under-seat compartment) by unscrewing the battery compar…
How to replace the battery of the Kymco Agility 200i?
How to replace the battery of the Kymco Agility 200i?
Agility 200i To replace the battery on the Kymco Agility 200i, loosen the screws securing the panel located in the centre of the bike, corresponding to the footre…
Removing the Shield and Replacing the Dipped or Main Beam Bulb in the Kimco Agility 200i
Removing the Shield and Replacing the Dipped or Main Beam Bulb in the Kimco Agility 200i
Agility 200i To remove the front shield and replace the dipped beam bulb, first position the motorcycle securely for working on it. Using a screwdriver or a small…

How to Replace the Drive Belt of the Piaggio Vespa 50 ET2

Today, we will discover the instructions that will allow us to dismantle and replace the drive belt of the Piaggio Vespa 50 ET2. First, place the scooter on the stand and start unscrewing all the fixing screws found on the side of the transmission cover to remove it; then unscrew the screw of the fan and the variator, subsequently removing the drive belt, as shown in the video. At this point, install the new toothed belt, as well as the original one, correctly refitting the fan and finally the side cover of the transmission.

Watch the video!


by ScegliAuto

More videos