Do it yourself
Frequently asked questions about cars and motorcycles
To replace the battery on the Kymco Agility 200i, loosen the screws securing the panel located in the centre of the bike, corresponding to the footrest area. Once the screws are loosened, you can remove the panel to access the battery. Remove the battery from its housing by unscrewing the securing screws and disconnecting the power cables, allowing you to replace it with a new one. After the replacement, cover everything with the panel, ensuring everything functions correctly.

Updated on 26 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Agility 200i First, remove the scooter's battery (unfortunately, the only access is from here, behind the under-seat compartment) by unscrewing the battery compar…
Agility 200i Remove the cap from the centre of the shield and unscrew the now-exposed screw with a crosshead screwdriver, then unscrew the screw underneath (going…
Agility 200i To remove the front shield and replace the dipped beam bulb, first position the motorcycle securely for working on it. Using a screwdriver or a small…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos