Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Before you can begin, sit on the seat of your Kymco People 250. Start by inserting the key into the ignition switch and turning it fully clockwise. Once done, pull and hold the brake lever, then press and hold the start button located under the throttle grip. At this point, keep it pressed until the engine of your Kymco People 250 starts. When it has started, you can stop pressing the start button, and you will have completed the procedure.

Updated on 17 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Maintenance Light on a Kymco People 250
How to Reset the Maintenance Light on a Kymco People 250
People 250 Before you begin, ensure that the service has been completed. Start by sitting on the seat of your Kymco People 250. Next, insert and turn the key in…
How to Replace the Belt on the Kymco People 250
How to Replace the Belt on the Kymco People 250
People 250 You can replace the drive belt on the Kymco People 250 by loosening the screws that secure the transmission cover, located on the left side near the …
How to reassemble the front wheel of the Kymco People 250
How to reassemble the front wheel of the Kymco People 250
People 250 In these short and simple steps, we will see how to install the front wheel of the Kymco People 250 scooter. First, we put the scooter on the center …

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos