|
Do it yourself
| |||
| ||||
|
Model: Kymco People 250
Before you begin, ensure that the service has been completed. Start by sitting on the seat of your Kymco People 250. Next, insert and turn the key in the ignition switch. Once done, press and hold the right button located beneath the left side of the instrument panel. Continue holding it until the maintenance light on your Kymco People 250 turns off. When the light goes out, you can release the button, and you will have successfully completed the reset procedure.
Updated on 16 May 2026 by ScegliAuto
Video tutorial
Related tutorials
People 250
Before you can begin, sit on the seat of your Kymco People 250. Start by inserting the key into the ignition switch and turning it fully clockwise. O…
People 250
You can replace the drive belt on the Kymco People 250 by loosening the screws that secure the transmission cover, located on the left side near the …
People 250
In these short and simple steps, we will see how to install the front wheel of the Kymco People 250 scooter. First, we put the scooter on the center …
|
How to Replace the Front Headlight on the BMW F800GS
In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.092
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
