Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the light control unit of the Kymco People 250 S.

Model: Kymco People 250
Part: Control unit

Video tutorial

In this guide, we will see the instructions that will allow us to disassemble and replace the light control unit of the Kymco People 250 S scooter. First, let's put the scooter on the stand and start by removing the left side plastic cover, located next to the turn signal light; inside, we will find the light control unit, disconnecting the two electrical connectors to remove it, as shown in the video.

At this point, we will install the new light control unit, making the electrical connections; then we will check the correct functioning of all the bulbs, both front and rear.


Posted on 27 December 2025 by ScegliAuto


Related tutorials

How to Reset the Maintenance Light on a Kymco People 250
How to Reset the Maintenance Light on a Kymco People 250
People 250 Before you begin, ensure that the service has been completed. Start by sitting on the seat of your Kymco People 250. Next, insert and turn the key in…
How to Start a Kymco People 250
How to Start a Kymco People 250
People 250 Before you can begin, sit on the seat of your Kymco People 250. Start by inserting the key into the ignition switch and turning it fully clockwise. O…
How to Replace the Belt on the Kymco People 250
How to Replace the Belt on the Kymco People 250
People 250 You can replace the drive belt on the Kymco People 250 by loosening the screws that secure the transmission cover, located on the left side near the …

How to Replace the Front Headlight Bulbs in the Aprilia Tuono V4 1100?

In this tutorial, you will see how to replace the front headlight bulbs in the Aprilia Tuono V4 1100, a very simple and quick operation. Before proceeding, ensure that the key is not inserted for safety. Start by positioning yourself near the headlight in question, then locate and open the circular cap at the back of it. Next, disconnect the power connector, unclip the metal clip, and remove the old bulb from its housing. Finally, insert the replacement bulb without touching the glass with bare hands and follow the reverse procedure to reassemble everything.

Watch the video!


by ScegliAuto

More videos