Do it yourself
Frequently asked questions about cars and motorcycles
Today, we will see in this short tutorial how to remove and replace the spark plug on the Kymco People S 250 scooter in simple steps. First, place the scooter on its centre stand and start by removing the entire under-seat compartment by unscrewing the fixing screws. Then, disconnect the spark plug connector or cap found at the bottom, as shown in the video. At this point, remove the side plastic cover to access the spark plug, using a socket wrench to unscrew and remove it; replace it with a new one that has the correct heat rating.

Updated on 4 June 2026 by ScegliAuto

Video tutorial

Related tutorials

People 250 Before you begin, ensure that the service has been completed. Start by sitting on the seat of your Kymco People 250. Next, insert and turn the key in…
People 250 Before you can begin, sit on the seat of your Kymco People 250. Start by inserting the key into the ignition switch and turning it fully clockwise. O…
People 250 You can replace the drive belt on the Kymco People 250 by loosening the screws that secure the transmission cover, located on the left side near the …

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos