Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the headlight bulb on the Kymco Super Dink 300, unscrew the screws and detach the internal clips that secure the front trim of the motorcycle. This will allow you to loosen the bolts that hold the front fairing under the windscreen, removing both parts. Their removal will provide access to the bulb housing: you can replace the bulbs by detaching the inner circular cover and disconnecting them from the connectors, allowing you to install the new replacement parts. After installation, refit all previously removed components.

Updated on 6 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you reset the Service light of the Kymco Super Dink 300?
How do you reset the Service light of the Kymco Super Dink 300?
Super Dink 300 In order to reset the Service light on the Kymco Super Dink 300, you need to turn on the instrument panel by inserting the ignition key into the corr…
How to Change the Engine Oil on a Kymco Super Dink 300 Scooter
How to Change the Engine Oil on a Kymco Super Dink 300 Scooter
Super Dink 300 In this tutorial, learn how to change the engine oil on a Kymco Super Dink 300 scooter, a very simple and quick operation. First, wait until the engi…
How to Replace the Rear Brake Pads on a Kymco Super Dink 300 Scooter?
How to Replace the Rear Brake Pads on a Kymco Super Dink 300 Scooter?
Super Dink 300 In this tutorial, you will learn how to replace the rear brake pads on a Kymco Super Dink 300 scooter, a very simple and quick operation. First, ensu…

How to Replace the Battery in a Yamaha FZ6?

Replacing the battery in the Yamaha FZ6, as shown in this tutorial, is a very simple and quick operation. First, ensure that the key is not inserted, then remove the rider's seat and, using a 10mm socket spanner, loosen the bolt on the tank hinge. Next, unscrew both the front bolts and the fairing mounting bolts, lift the entire tank, and disconnect both terminals starting with the negative. At this point, you can remove the upper plastic plate, take the battery out of its housing, and fit the replacement.

Watch the video!


by ScegliAuto

More videos