Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today, discover the guide that will allow you to dismantle and replace the rear light bulb of the Kymco Super 8 125 scooter. First, place your scooter on the centre stand and begin by lifting the seat; then disconnect the electrical connector of the bulb by rotating it to remove it from the rear light, as shown in the video. At this point, install the new stop bulb of the correct type and with the same fitting; test its operation and finally refit the protective plastic cover, following the video tutorial to the end!

Updated on 4 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the rear headlight bulb of the Kymco Super 8 125?
How do you replace the rear headlight bulb of the Kymco Super 8 125?
Super 8 125 In order to replace the rear headlight bulb of the Kymco Super 8 125, you need to open the underseat compartment, so that you can locate the screws a…
How to Replace the Exhaust on a Kymco Super 8 125?
How to Replace the Exhaust on a Kymco Super 8 125?
Super 8 125 To replace the exhaust on a Kymco Super 8 125, loosen the screws that secure the exhaust end can to its mounting near the rear wheel on the right sid…
How to Replace the Air Filter on a Kymco Super 8 125
How to Replace the Air Filter on a Kymco Super 8 125
Super 8 125 Before you start, position your Kymco Super 8 125 on the centre stand. First, unscrew and remove the screws securing the air filter cover. Next, dise…

How to replace the coolant in the BMW S1000 R

Today, we will see in this video tutorial how to bleed and replace the coolant in the BMW S1000 R motorcycle. First, place your motorcycle on a stand and start unscrewing the bleed screw located on the water pump casing, found at the bottom right; let the fluid drain into a container for about ten minutes. Now, unscrew the radiator cap and top up with the new coolant, the correct type for your radiator; fill it to the maximum level mark, starting the engine to circulate the fluid!

Watch the video!


by ScegliAuto

More videos