Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kymco Agility 50
Part:

This guide provides the main instructions for removing and replacing the drive belt on the Kymco Agility 50 scooter. First, place the scooter on its central stand and begin unscrewing the screws securing the transmission cover to remove it; then unscrew the central nut of the fan and the one on the clutch bell, subsequently removing the drive belt and variator, as shown in the video. At this point, install the new original drive belt, inserting it correctly, and reassemble everything!

Updated on 18 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Variator on the Kymco Agility 50?
Agility 50 To replace the variator on the Kymco Agility 50, loosen the screws securing the transmission cover located near the rear wheel on the left side of th…
How to Replace the Variator on a Kymco Agility 50
How to Replace the Variator on a Kymco Agility 50
Agility 50 This video shows the procedure for disassembling and replacing the variator and rollers, as well as the drive belt, on the Kymco Agility 50 scooter. …
How to Replace the Rollers of the Kymco Agility 50 Variator
How to Replace the Rollers of the Kymco Agility 50 Variator
Agility 50 In this video, see how to dismantle and replace the rollers of the variator on the Kymco Agility 50cc scooter in simple steps. First, place the scoot…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos