Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Lml Star 200 Spark Plug Maintenance

Model: Lml Star 200
Part: Spark plugs

Video tutorial

Lml recommends changing the spark plug every 7,500 miles (but it often needs changing sooner) and checking it for safety every 1,875 miles. If you notice the engine struggles to start, it is likely due to the spark plug.

Remove the cap and its rubber boot. Using the appropriate socket wrench, unscrew the spark plug.

Check for excessive deposits and clean it with a wire brush until it is truly clean. Use fine sandpaper to further clean it. With a feeler gauge, check that the gap from the electrode is 0.7 to 0.8 mm. Reassemble everything.


Updated on 8 April 2026 by ScegliAuto


Related tutorials

How do you replace the timing chain of the LML Star 200?
How do you replace the timing chain of the LML Star 200?
Star 200 To replace the timing chain tensioner of the LML Star 200, you need to loosen the screws that secure the component to its housing: this will be locat…
How to Replace the Fuel Pump on an LML Star 200?
How to Replace the Fuel Pump on an LML Star 200?
Star 200 To replace the fuel pump on an LML Star 200, loosen the screws securing the right side cover panel of the bike, located near the rear wheel: once thi…
Guide to Removing the Engine Block of the LML Star 200
Guide to Removing the Engine Block of the LML Star 200
Star 200 In this brief and simple guide, you will find instructions to remove and open the engine block of the LML Star 200, as well as the Piaggio Vespa PX 2…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos