Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the O-Rings on the Clutch Cover of the LML Star 125-150

Model: Lml Star 125

Video tutorial

In this video, you will see how to replace the O-rings on the clutch cover in case of an oil leak on an LML Star 125 or 150. First, remove the rear wheel, then drain the engine oil; next, use a socket to remove the rear drum, and then unscrew the screws of the brake plate.

At this point, unscrew the fixing screws of the filter and the clutch cover to remove it; now pull out the lever rod and replace the O-rings inside, as shown in the video!


Updated on 16 April 2026 by ScegliAuto


Related tutorials

Removing the Starter Motor from the Lml Star 125-150
Removing the Starter Motor from the Lml Star 125-150
Star 125 Discover the main steps to remove and replace the starter motor of the Lml Star 125 and 150 in this brief video. First, disconnect the electrical con…
How to Replace the Grips on an LML Star 125-150-200
How to Replace the Grips on an LML Star 125-150-200
Star 125 In this short video tutorial, you will see how to remove and replace the original grips on an LML Star 125-150-200, as well as on a Piaggio Vespa PX.…
How to Replace the Battery on LML Star 125-150-200
How to Replace the Battery on LML Star 125-150-200
Star 125 In this video, you will see how to dismantle and replace the battery on an LML Star 125, as well as on the 150 and 200 models. First, remove the left…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos