Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Lml
    3. :
  3. Star 125
    4. : How to replace the battery on LML Star 125-150-200

Model: Lml Star 125
Part: Battery
How to replace the battery on LML Star 125-150-200

Let's see in this video how to remove and replace the battery on an LML Star 125, but also on the 150 and 200. First we are going to remove the left side case of our vehicle; to do this, we lift the seat and release the two levers that we find near the tank. Once removed, disconnect the two battery terminals (positive and negative pole); then we unfasten the two holding cables and remove the battery. We just have to replace it with the new one, of the right type and with the same amperage, following the video tutorial until the end!


Posted on 27 March 2024 by ScegliAuto



How to replace the knobs on LML Star 125-150-200
Star 125 Let's see in this short video tutorial how to remove and replace the original knobs on an LML Star 125-150-200, but also on the Piaggio Vespa PX. To
How to replace the voltage regulator on LML Star 125
Star 125 In this video we will see the steps that will allow us to remove and replace the voltage regulator on an LML Star 125cc, but also on the 150 and 200.
Disassembly of the LML Star 125 fuel tank - Piaggio Vespa PX
Star 125 Let's see in this video how to remove the fuel tank on an LML Star 125, but also on the Piaggio Vespa PX of all 125-150-200. First of all we go to li

How to bleed the brake system of the Kymco GP125

The guide shows how to bleed the Kymco GP125 brake oil system. After securing the vehicle and protecting the upper fairing with rags, unscrew the two fixing screws of the brake fluid reservoir cap and remove the covers. Using an 8mm wrench, loosen the bleed valve on the front caliper and install the drain hose. Activate the brake to let the fluid flow out of the system. Remove the brake caliper, push the piston all the way and clean it with a special spray. Reassemble everything in place and, if necessary, top up the fluid. Check the correct functioning of the brakes before taking the road.

Watch the video!


by ScegliAuto

More videos