Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Check the Stator Function on the LML Star 200

Model: Lml Star 200
Part: Checks and maintenance

Video tutorial

In this video tutorial, you will learn how to check the function of the stator, which sends electrical current, on the LML Star 200, as well as on the 122, 150, and Piaggio Vespa PX. First, remove the fan cover and the fan itself by unscrewing the central nut of the flywheel; then remove the stator by disconnecting the wires and unscrewing the screws.

At this point, use a multimeter set to ohms; check the resistance between the green and white wire to verify its function.

Follow the video to the end!


Updated on 22 April 2026 by ScegliAuto


Related tutorials

Guide to Removing the Engine Block of the LML Star 200
Guide to Removing the Engine Block of the LML Star 200
Star 200 In this brief and simple guide, you will find instructions to remove and open the engine block of the LML Star 200, as well as the Piaggio Vespa PX 2…
How to replace the clutch on the LML Star 200?
How to replace the clutch on the LML Star 200?
Star 200 To replace the clutch on the LML Star 200, loosen the screws that secure the transmission cover located on the right side of the bike: once this cove…
How do you replace the clutch of the LML Star 200?
How do you replace the clutch of the LML Star 200?
Star 200 It will be possible to replace the clutch of the LML Star 200 by loosening the screws that fix the transmission housing located near the rear wheel, …

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos