Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Malaguti F10
Part:

Clean the fork from dirt or mud, especially around the seals. Disassembly: deflate the fork and remove the valve core. Remove the bolts from the bottom of the fork, leaving a small gap between the nut and the foot. Use a hammer and a wrench to unlock the stems from the feet. Drain the old oil from the fork and completely remove the stems. Clean the inside of the sliders with isopropyl alcohol and a piece of paper. Remove the old seals and dust seals with a metal tire lever. Install the new seals and dust seals with a special tool and a hammer. Soak the foam rings in oil and insert them under the dust seals. Apply a thin layer of grease on the dust seals.

Posted on 16 January 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Fuel Tank on a Malaguti F10?
How to Replace the Fuel Tank on a Malaguti F10?
F10 To replace the fuel tank on a Malaguti F10, you need to completely dismantle the under-seat compartment of the bike by unscrewing the appropriate bol…
Gear Oil Change for Malaguti F10 50cc
Gear Oil Change for Malaguti F10 50cc
F10 In this tutorial, you will learn how to change the gear oil of a Malaguti F10 50cc. First, place a container under the oil drain plug to catch the oi…
How do you replace the front brake disc of the Malaguti F10?
How do you replace the front brake disc of the Malaguti F10?
F10 In order to replace the front brake disc of the Malaguti F10, you need to loosen the side nuts that secure the front wheel to its housing: once these…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos