Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. Cx7
    4. : Checks and maintenance

Mazda Cx7 - Checks and maintenance

Mazda Cx7 (2006-2012 / MK 1)
TCS system reset for Mazda CX7.
In this video, we see that if there is a power interruption on the Mazda Cx7, for example following the replacement of the battery, it may happen that the TCS …read all…
Posted on 4 March 2024 by ScegliAuto
Mazda Cx7 (2006-2012 / MK 1)
How do you reset the particulate filter warning light on the Mazda CX7?
In order to reset the Mazda CX7 particulate filter warning light, you must turn off the instrument cluster and connect a wire from the top terminal of the …read all…
Posted on 12 March 2024 by ScegliAuto
Mazda Cx7 (2006-2012 / MK 1)
Oil filter exchanger gasket replacement
In order to replace the oil filter exchanger gasket it is necessary to proceed as follows; drain the engine oil through the special drain plug located under …read all…
Posted on 17 August 2023 by ScegliAuto
Car stereo (3) Battery (1) Spark plugs (1) Bodywork (1) Key (3) Checks and maintenance (3) Diesel filter (1) Accessory Kit (1) Light bulb (2) Headlight bulb (2) Rear light bulb (1) License plate light (1) Window motor (1) Engine oil (1) Lambda sensor (1) Turbine (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos