Do it yourself
Frequently asked questions about cars and motorcycles

Replacement of the AC Drive Belt

Model: Mazda 3 BK, MK 1 - Years 2003-2009
Part: V-belt

This guide shows how to replace the air conditioning drive belt. Once you locate the belt, check if it needs replacing; if it is worn, you can cut it directly with scissors for easier removal. To install the new belt, position it on the pulley and, using a lever tool or similar, pry to insert the belt into its housing; rotate the pulley and also use your fingers to push the belt to achieve correct alignment.

Updated on 10 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Mazda 3 (2009-2013 / MK 2, BL) First, use a plastic trim tool to remove the plastic covers located at the bottom (towards the inside) under the lower edge of the front and rear doo…
Mazda 3 (2003-2009 / BK, MK 1) To replace the air conditioning compressor, lift the vehicle on a hydraulic lift as the compressor is located at the bottom of the engine bay. Once t…
Mazda 3 (2003-2009 / BK, MK 1) In this tutorial, you can see how to remove the climate control console in the Mazda 3, a very simple and quick operation. First, ensure that the key…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos