Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Rear Shock Absorbers

Model: Mazda 5 MK 1 - Years 2005-2015
Part: Shocks

Loosen the fastening pins of the rear wheel before lifting it and placing it on suitable axle stands; complete the wheel removal to access the flange of the upper shock absorber mount and disassemble the relevant fastening pins; then remove the fastening pin of the shock absorber eye to the rear axle and extract it from its location; unscrew the fastening nut of the upper shock absorber mount from the respective stem to apply it to the new shock absorber, first inserting the protective boot; then install the new shock absorber.

Updated on 11 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Engine Oil and Oil Filter Replacement
Engine Oil and Oil Filter Replacement
Mazda 5 (2005-2015 / MK 1) Place chocks under the rear wheels and lift the front with a jack positioned at the centre. Remove the splash guard to access the oil sump: place a s…
Replacement of the Car Cabin Air Filter
Replacement of the Car Cabin Air Filter
Mazda 5 (2005-2015 / MK 1) Replacing the pollen filter in your car is a very important task as it protects against external agents entering the cabin, preserving the health of …
Replacing Engine Oil and Oil Filter
Replacing Engine Oil and Oil Filter
Mazda 5 (2005-2015 / MK 1) To replace the engine oil and the corresponding filter, position the vehicle on suitable car ramps to facilitate access to the oil sump; unscrew the …

Remove the Front Door Panel on Mercedes C

Remove the front door panel on Mercedes C to access the window switch assembly. Disconnect the battery terminals in the engine compartment. Use a screwdriver to remove the screws located in the upper lever opening area and the screws in the handle (after removing the plastic screw covers). Remove the trim near the lock, unscrew any remaining screws on the door panel, and detach the retaining clips. Finally, pull off the panel and disconnect it from the door (unplug the power harness and the opening cable). Unscrew or detach the retaining clips of the window switch assembly.

Watch the video!


by ScegliAuto

More videos