Do it yourself
Frequently asked questions about cars and motorcycles

How to Remove and Replace the Boot Seal on a Mazda 3

Model: Mazda 3 BK, MK 1 - Years 2003-2009

This guide shows you how to remove and replace the boot seal on a Mazda 3 in simple and quick steps. First, open the tailgate and start to unclip and remove the boot seal from the sides; then clean the sides and base where the seal sits with a cloth and a degreasing product, as shown in the video. At this point, install the new boot seal in the correct orientation, securing it properly on the sides; then check that the tailgate closes correctly!

Updated on 3 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Mazda 3 (2003-2009 / BK, MK 1) Today we will discover the instructions that will allow us to disassemble and replace the rear tail light and its bulbs of the Mazda 3. First of all,…
Mazda 3 (2009-2013 / MK 2, BL) In this tutorial, see how to remove the rear lights from the Mazda 3, a very simple and quick operation, necessary if you need to replace a bulb or t…
Mazda 3 (2003-2009 / BK, MK 1) In this tutorial, you can see how to remove the climate control console in the Mazda 3, a very simple and quick operation. First, ensure that the key…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos