Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Intake Manifold on Mercedes E-Class W211

Model: Mercedes Classe E W211 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Engine

See other generations:
Video tutorial

Remove the three 10 mm bolts securing the rail. Using 13 mm and 14 mm wrenches, unscrew the connections between the injectors and the fuel lines.

With 14 mm and 17 mm wrenches, disconnect the rail from the injection pump. Remove the rail by unscrewing the 17 mm bolt with two washers.

Remove the fuel filter after disconnecting its lines and unscrewing the bolts that secure it. Unscrew the bolts securing the intake duct, disconnect everything associated with it (such as the pressure sensor), and finally remove it. Proceed in reverse for reassembly.

This is a lengthy job and not suitable for everyone.


Updated on 11 April 2026 by ScegliAuto


Related tutorials

How to Replace the Intake Manifold on a Mercedes E-Class?
How to Replace the Intake Manifold on a Mercedes E-Class?
Mercedes Classe E (1995-2002 / W210) To replace the intake manifold on a Mercedes E-Class, open the hood to access the components in the engine bay. Loosen the screws securing the cover …
Removing the Rear Interior Light Fixture on Mercedes E-Class W211
Removing the Rear Interior Light Fixture on Mercedes E-Class W211
Mercedes Classe E (2002-2009 / W211) .. the rear interior light fixture on a Mercedes E-Class W211, fourth generation. First, get inside the vehicle and obtain a very thin plastic trim tool;.. …
How to Replace the Power Steering Pump on the Mercedes E-Class W211
How to Replace the Power Steering Pump on the Mercedes E-Class W211
Mercedes Classe E (2002-2009 / W211) .. the power steering pump on the Mercedes Benz E-Class W211, following the instructions below. First, open the hood of your car and start by removing.. …

How to Activate the Disabled TRC on the Toyota Yaris?

As the video clearly shows, disabling or activating the traction control (TRC or ESP) on the Toyota Yaris is very simple. By default, the traction system activates every time the vehicle is started. To disable it, simply press the button depicting a skidding car located in the centre of the vehicle where the controls are, such as the hazard lights and the radio, but near the handbrake. Once disabled, the TRC off light will illuminate on the dashboard. To reactivate it, just press the same button again.

Watch the video!


by ScegliAuto

More videos