Do it yourself
| ||||
|
Mercedes Classe C - Video tutorial
Model: Mercedes Classe C
W203
- Years 2000-2007 Remove the suction duct completely and carefully remove the protective cover. In order not to confuse the cables, disconnect only the first spark plug. Using a ratchet wrench, unscrew the coil sealing screw connected to the first spark plugs and slide the connection pipette upwards. Check the number on the spool and the number on the pipettes. At the bottom of the cockpit is the first candle. Before proceeding with disassembly, carefully clean the pits with compressed air to eliminate any dirt that could fall into the combustion chamber. Using the special spark plug wrench, which has a rubber hooking device, gently insert it on the spark plug head and unscrew it. Be careful not to let foreign bodies fall into the pit. Replace the spark plug with one of the same model by carefully inserting it into the well, again using the special wrench and turning it gently, checking that it is screwed on correctly. In case of effort, remove it and try again. The spark plugs must be screwed with a torque wrench, if you do not have the wrench screwed in without over tightening. Proceed with the same operation with the other candles. Clean the pipette leads and contacts with an antioxidant spray before reassembling them.
Posted on 18 July 2023 by ScegliAuto
Other guides that may interest you
|
Handbrake adjustment on Ford EcosportFirst remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.011
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |