Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : How to replace the cabin filter on the Mercedes C-Class W202.

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W202 - Years 1993-2000
Part: Cabin air filter
Operation: How to replace the cabin filter on the Mercedes C-Class W202.

If you want to replace the cabin air filter of your Mercedes C-Class W202 (year 1993-2000) by yourself but don't know how to do it, don't worry because below you will find all the necessary steps described. First of all, turn off the car and reach the front passenger seat. At this point, get a flathead screwdriver and unscrew all the various screws in the lower area of the glove compartment. Immediately after, remove the panel and locate the air filter. Then remove it and, finally, replace it with a new one perfectly compatible with your car.


Posted on 4 April 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Classe C 2007-2013 - Where is the cabin air filter of the 2013 Mercedes C220 CDI coupe located? Read Answer
    • Classe C 2007-2013 - How much does the Mercedes C-Class 220 cabin air filter cost? Read Answer
    • Classe C 2007-2013 - Where is the air conditioning filter of the Mercedes CW 204 class? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos