Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mini
    3. :
  3. Mini
    4. : Horn emitter replacement

Mini - Video tutorial

Model: Mini Mini F55, F57, F56 - Years 2014-2023
Part: Accessory Kit
Operation: Horn emitter replacement

Open and lift the hood, remove the clips that lock the front grille above the bumper, now pulling the grille panel forward slightly you can unscrew the screws that lock it from the base. Lift your car and remove the clips located on the lower part of the bumper, pay attention only the front ones to the ground, now remove the clips that block the bumper from the inside of the fender, in this way you can disconnect the connectors behind the fender panel . Also remove the clips that lock the edge of the fender in this way you can remove the bolt that locks the front bumper, to unlock it definitively, also remove the bolts located on the vertical brackets in front of the radiator, pull the bumper towards you to extract it. Locate the horn on the left side of your car, free it from the various bolts that block it and disconnect it from the connector. Follow the steps in reverse for reassembly.


Posted on 21 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Mini 2014-2023 - Where is the puncture kit located on a Mini Countryman? Read Answer
    • Mini 2010-2016 - Can a spare wheel be accommodated in the Mini Countryman? Read Answer

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos