Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the voltage regulator on the Moto Guzzi V7 III Rough.

Model: Moto Guzzi V7 Iii

Video tutorial

These brief and simple steps will show us how to disassemble and replace the voltage regulator of the Moto Guzzi V7 III Rough. First, we place the motorcycle on the stand and start unscrewing the fastening screws located at the front, using a star or socket wrench; then we disconnect the electrical connectors of the voltage regulator in order to remove it, as shown in the video.

At this point, we install and connect the new voltage regulator correctly; to check its operation, we start the engine and check the battery voltage at the terminals.


Posted on 27 November 2025 by ScegliAuto


Related tutorials

How to disassemble and repair the speedometer of the Moto Guzzi V7 III
How to disassemble and repair the speedometer of the Moto Guzzi V7 III
V7 Iii Below we will see the step-by-step instructions that will allow us to disassemble and repair the speedometer of the Moto Guzzi V7 III. First, we put …
How to disassemble the rear light of the Moto Guzzi V7 III Stone.
How to disassemble the rear light of the Moto Guzzi V7 III Stone.
V7 Iii In this guide, we will go through the instructions that will allow us to disassemble and replace the rear light of the Moto Guzzi V7 III Stone. First…
How do you replace the air filter of the Moto Guzzi V7 III?
How do you replace the air filter of the Moto Guzzi V7 III?
V7 Iii In order to replace the air filter of the Moto Guzzi V7 III, you need to insert the key into the lock located under the seat, on the left side of the…

How to Replace the Headlight Bulb on the Suzuki Address 110

To replace the headlight bulb on the Suzuki Address 110, you must completely remove the wing mirrors so that you can rotate them counterclockwise: once removed, proceed to loosen the screws securing the front fairing, located at the sides of the instrument cluster. Once the front fairing is removed, disconnect the internal connector of the headlight, allowing the bulb inside to be extracted and replaced with a new one; after replacement, reassemble all the removed parts.

Watch the video!


by ScegliAuto

More videos