Do it yourself
Frequently asked questions about cars and motorcycles
Below we will see the step-by-step instructions that will allow us to disassemble and repair the speedometer of the Moto Guzzi V7 III. First, we put the motorcycle on the stand and start removing the rear part of the instrument panel; we then disconnect the speedometer cable and the electrical connector of the instrument panel bulb, as shown in the video. At this point, we unscrew the screws of the panel to remove it, carrying out the repair if necessary; we install and connect the instrument panel correctly, then check its operation.

Posted on 14 October 2025 by ScegliAuto

Video tutorial

Related tutorials

V7 Iii In this guide, we will go through the instructions that will allow us to disassemble and replace the rear light of the Moto Guzzi V7 III Stone. First…
V7 Iii These brief and simple steps will show us how to disassemble and replace the voltage regulator of the Moto Guzzi V7 III Rough. First, we place the mo…
V7 Iii In this video tutorial, you will learn how to install rearsets on the Moto Guzzi V7 III, following the instructions below. First, place the stand on …

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos