Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the coolant on MV Agusta F4 1078RR

Model: Mvagusta F4 1078rr

Video tutorial

Remove the left fairing by unscrewing the fixing screws, then remove the front fairing beneath the bike and finally the right fairing. Unscrew the two screws near the ignition and remove the protection present here.

Unscrew the top cap at this point: remember to perform this operation only when the engine is cold. Unscrew the bolt that acts as a cap for the coolant drain hole and collect the coolant in a container (dispose of it properly at designated recycling points).

Tighten the drain bolt to 8 Nm and refill with new coolant.


Updated on 30 April 2026 by ScegliAuto


Related tutorials

How to Replace the Radiator on the MV Agusta F4 1078RR?
How to Replace the Radiator on the MV Agusta F4 1078RR?
F4 1078rr To replace the radiator on the MV Agusta F4 1078RR, loosen the screws that secure it to its housing at the front of the bike, just behind the front w…
How do you bleed the brakes on the MV Agusta F4 1078RR?
How do you bleed the brakes on the MV Agusta F4 1078RR?
F4 1078rr To perform the brake bleeding on the MV Agusta F4 1078RR, you need to loosen the drain plug that allows the brake fluid to escape from the respective…
How to Replace the Exhaust on the MV Agusta F4 1078RR?
How to Replace the Exhaust on the MV Agusta F4 1078RR?
F4 1078rr The procedure for replacing the exhaust on the MV Agusta F4 1078RR can be carried out by loosening the screws that secure the exhaust at the rear, ne…

How to Replace the Headlight Bulb on the Suzuki Address 110

To replace the headlight bulb on the Suzuki Address 110, you must completely remove the wing mirrors so that you can rotate them counterclockwise: once removed, proceed to loosen the screws securing the front fairing, located at the sides of the instrument cluster. Once the front fairing is removed, disconnect the internal connector of the headlight, allowing the bulb inside to be extracted and replaced with a new one; after replacement, reassemble all the removed parts.

Watch the video!


by ScegliAuto

More videos