|
Do it yourself
| |||
| ||||
Where to Find the Fuses on the Nissan Qashqai
Model: Nissan Qashqai
J10
- Years:
2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Video tutorial
To check or potentially replace the fuses in the Nissan Qashqai, there is a small cover on the left side of the steering wheel. Pull it open to access the fuses, and the cover should indicate what each fuse is for and its amperage. If you do not find the correct fuse inside the car, check under the bonnet. On the right side of the battery, there is a box; lift the snap-on lid to find the fuses, with the cover indicating their purpose and amperage. To extract a fuse from the fuse box in the dashboard, there is a special tool for removing fuses. Remove the fuse you want to check, and if the bridge is broken, replace the fuse; if the bridge is intact, you can gently put it back in place. THE NEW FUSE MUST HAVE THE SAME AMPERAGE AS THE FUSE BEING REPLACED.
Updated on 2 June 2026 by ScegliAuto
Related tutorials
Nissan Qashqai
(2014-2022 /
J11)
The fuses on a Nissan Qashqai are located inside the dedicated fuse box in the car. This is situated on the side of the dashboard, accessible only by…
Nissan Qashqai
(2014-2022 /
J11)
The fuse boxes present on the Nissan Qashqai are designed to contain the fuses that are present on the vehicle: in this type of vehicle there will be…
Nissan Qashqai
(2006-2014 /
J10)
The fuses on a Nissan Qashqai are located inside the designated fuse boxes within the vehicle: this model has two boxes in the engine compartment and…
Other guides you may be interested in
|
Frequently Asked QuestionsHow to Extract the Spare Wheel from a Mercedes Vito
The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.371
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |