|
Do it yourself
| |||
| ||||
How to replace the injectors on an Opel Astra
Model: Vauxhall Astra
Astra J
- Years:
2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Video tutorial
Today, we will explain how to replace the injectors on the Opel Astra model J. Before starting the replacement, it is important to remove any diesel from the fuel rail and disconnect the negative terminal of the battery for safety. Remove the engine cover and detach the air filter box along with the air duct. Next, disconnect the injectors by pressing on the fastening clips. Using a socket wrench, unscrew the injectors. Replace the seals and before inserting the new injectors into their seats, lubricate them with grease. It is important to follow the torque specifications for each injector. Reconnect the electrical cables and mount the engine cover. Before that, reattach the air filter box and the air duct, and reconnect the negative terminal of the battery.
Posted on 27 September 2026 by ScegliAuto
Related tutorials
Vauxhall Astra
(2009-2016 /
Astra J)
In today’s video tutorial, we will see how to disassemble and replace the injectors on the engine of a 1.3 Diesel Opel Astra. First, open and lift th…
Vauxhall Astra
(2009-2016 /
Astra J)
In this guide, you will find the main instructions on how to remove and replace the injectors on the Opel Astra 1.3 CDTi. First, open the car's bonne…
Vauxhall Astra
(2004-2010 /
Astra H)
In this tutorial, you will learn how to remove and replace the windscreeen washer nozzles on the Opel Astra H by following these simple steps. First,…
Other guides you may be interested in
|
How to Extract the Spare Wheel from a Mercedes Vito
The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.162
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |