Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Removing the Rear Light

Model: Vauxhall Corsa Corsa C - Years 2000-2006
Part: Tail light

Removing the rear light is extremely simple as it is secured with just two easily accessible screws: once the rear hatch is open, the two screws securing the rear light are located along the internal closure line; unscrew the two securing screws and pull the light away from its housing, taking care not to damage the two plastic locating pins; then disconnect the power connector of the light, check for any signs of oxidation, and proceed in reverse for the installation of the light.

Updated on 14 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the rear light of the Opel Corsa
Replacement of the rear light of the Opel Corsa
Vauxhall Corsa (2006-2014 / Corsa D) Today's instructions will allow us to disassemble and replace the rear light and its bulbs of the Opel Corsa in simple steps. First, let's open the r…
How to replace the rear light bulbs of the Opel Corsa.
How to replace the rear light bulbs of the Opel Corsa.
Vauxhall Corsa (2006-2014 / Corsa D) Below we will see the necessary instructions to disassemble and replace the bulbs of the rear headlight of the Opel Corsa. First, we open the rear do…
Instructions for Removing the Third Brake Light
Instructions for Removing the Third Brake Light
Vauxhall Corsa (2000-2006 / Corsa C) The third brake light is located at the top edge of the rear tailgate, just above the heated rear window; it is secured with clips. To remove it, pul…

How to Install Roof Bars on a Fiat 500L

Learn how to fit universal roof bars on a Fiat 500L. These bars are used on vehicles with or without roof rails. Assemble the roof bar kit (as shown in the video) with bars adjusted to the width of the vehicle (measure with a tape measure). Position the brackets at both ends of the doors on the vehicle's original roof rails. Once the anchoring bracket width is set, tighten the bolts with a butterfly nut (if a lock is present) until fully secured to the roof rails. Fit safety caps on both sides.

Watch the video!


by ScegliAuto

More videos