|
Do it yourself
| |||
| ||||
|
Model: Peugeot Citystar 125
To replace the coolant in the Peugeot Citystar 125, open the designated drain cap located on the right side of the bike. To open the cap, you will need to unscrew the screw above it: collect the used coolant in a suitable container placed underneath the drain. Once the coolant has completely drained, top up with new coolant by pouring it into the designated channel. After pouring in the new coolant, close the channel with the cap.
Updated on 8 August 2026 by ScegliAuto
Video tutorial
Related tutorials
Citystar 125
To replace the coolant in the Peugeot Citystar 125, open the designated drain plug located on the right side of the bike. To open the plug, you will …
Citystar 125
You can replace the transmission on a Peugeot Citystar 125 by loosening the screws that secure the corresponding cover located near the rear wheel on…
Citystar 125
To replace the fuel pump on a Peugeot Citystar 125, remove the protective panel located in the footwell of the bike and the one at the base of the se…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
