Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to adjust the carburetion of the Peugeot Vivacity 50

Model: Peugeot Viva City
Part: Checks and maintenance

Video tutorial

Below are the main steps to perform the basic carburetion on the Peugeot Vivacity 50 scooter. First, place the scooter on the centre stand and locate the carburettor, situated near the engine block; then adjust the carburetion screw, turning it about two or two and a half turns from the fully closed position, as shown in the video.

At this point, adjust the idle screw, trying to keep the engine at a low RPM; all that’s left is to test the engine's operation!


Updated on 30 August 2026 by ScegliAuto


Related tutorials

How do you replace the piston of the Peugeot Vivacity?
How do you replace the piston of the Peugeot Vivacity?
Viva City In order to replace the piston of the Peugeot Vivacity, you need to loosen the screws that secure the panel located at the back of the footrest compa…
How to Remove the Variator Cover on a Peugeot Vivacity
How to Remove the Variator Cover on a Peugeot Vivacity
Viva City Before you start, position your Peugeot Vivacity on its central stand. The variator cover is secured with Allen bolts around its perimeter. Begin by …
How to Dismantle the Engine of the Peugeot Vivacity
How to Dismantle the Engine of the Peugeot Vivacity
Viva City To dismantle the engine of the Peugeot Vivacity, loosen the screws that secure the cylinder to the top after removing the ignition coil and the spark…

How to Replace the O-ring on the Clutch Rod of the LML Star?

To replace the O-ring on the clutch rod of the LML Star, lift the bike to loosen the side panel located near the rear wheel. Next, unscrew all the screws securing the rear wheel and the corresponding transmission cover: by removing the clutch, you will be able to locate the rod positioned behind it. This rod can now be removed from its housing by unscrewing the fastening screws; after the old rod has been removed, slide out the O-ring, replace it with a new one, and reassemble all previously removed components.

Watch the video!


by ScegliAuto

More videos